Flat iron hair comes to damaging the hair, perhaps no other beauty or styling tool has earned such a bad repute as the flat iron. Flat irons and in fact all other styling tools can wreak havoc your hair if not used properly. The main damage caused by flat iron hair in heat damage, which leaves the hair dry, brittle and lusterless. However, it isn’t impossible to avoid such condition. By following a few simple tips, you can get your hair straightened without putting up with the effects of heat damage.
Best Way to Protect Damage Hair With Flat Iron Hair…
While buying a flat iron, always invest in a high-quality iron with ceramic, jade or tourmaline heating plates. These materials heat the tresses in the fashion as microwave oven heats food, from the inside out. Such heat reduces the hair damage.
Never use flat iron on daily basis as its frequent use will cause irreparable damage to your hair. Dermatologists suggest not using the flat iron or other styling tools that involve heat more than thrice a week.
Make sure to moisturize your hair inside out before styling. You can use a moisturizing shampoo, conditioner or even a leave-in conditioner for this purpose. Doing a restorative deep-conditioning treatment is also a great option for keeping the hair and scalp well-moisturized and hydrated all the time.
Your hair should be completely dry when you begin flat ironing it. Damp hair and heat are not a good combination as hair is the weakest when wet and thus is more prone to get damaged.
Don’t forget treating your hair with a heat-protectant product before exposing it to the iron or other heat-styling tools. Not only these heat-protectant serums and sprays protect the hair from heat, but also make the hair more manageable and easier to iron.
The flat iron hair you use should have variable temperature controls, so you can set the temperature as per your need. And try setting the iron at lowest possible heat to get the job done.
Always iron the hair in small sections. Ironing a thick piece needs multiple passes of the iron in order to straighten it. This, definitely, will cause more damage. The smaller sections, on the other hand, will be smoothened and straightened in one, two quick passes of iron and thus the damage will also be relatively lesser.